• Address: 9415 Redondo Dr, Dallas, TX 75218 (map)
• Date Posted: 10/16/09

Used but in working condition. I have run this in all stop positions both in forward and reverse with no problem. Motor runs smoothly in slow and fast modes. Tested again yesterday July 7, 2009.

Includes 2 complete die head sets from 1" to 4"; i.e. 1", 1 1/4", 1 1/2", 2", 2 1/2", 3", 3 1/2", and 4". These die heads sell for $500 each and the dies themselves sell for between $25 and $85 per set. Have manual and parts list for this. Some parts are still available from Curtis Toledo. This has a 3 phase 220 volt motor. There is no plug end just a 10' cable with 5 wires (3 hots, 1 neutral and a ground). Chances are if there were a plug end it would not be the one you would need and you would have to change it anyway. I have a 6' pig tail for hooking it up so you can see it run prior to purchase.

NOTE: ONLY HAS ONE METAL DOOR ON BOTTOM TO HOLD DIE HEADS. SOME DIES ARE MISSING OR HAVE CHIPPED TEETH. MISSING JUNCTION BOX COVER. ALSO ONE OF THE CUT-OFF KNIFES DOES NOT ADVANCE. SOME OF THE DIE HEADS ARE MISSING DIES AND/OR PARTS: ALL MISSING PARTS FROM ONE CAN BE FOUND ON ANOTHER AND ARE INTERCHANGEABLE.

This tool may be seen in White Rock area of Dallas, TX 75218 prior to bidding. Threader is pickup only and must be either paid for prior to pickup or paid for in cash when picking up, no checks or money orders are accepted at pickup time. I can load this for you only on a flat bed trailer using my engine hoist or onto a larger truck with a lift gate using my pallet jack. If you have a large truck without a lift gate you must supply whatever is needed to load it yourself! Please let me know if I need to get my engine hoist to load it for you since I store that at another location.

Don't miss this most excellent offer. Others sell the same threader for over $3,000 without the die heads a $4,000 value!

Print Ad